The Colony Concrete Lifting logoThe Colony Concrete LiftingThe Colony, TX
Walkway Concrete Repair photo

The Colony Concrete Lifting

Patio and Walkway Concrete Raising in The Colony, TX

Patio and walkway concrete raising in The Colony: foam injection for lakefront settling and seam gaps, free estimates.

  • 15+ Years local experience
  • 500+ Projects completed
  • Licensed & Insured

Serving The Colony and nearby communities.

Why does a lakefront patio settle faster than a driveway two blocks inland? The water table near Lewisville Lake shifts with rainfall, and that movement can undercut soil support beneath a patio slab well before a driveway further from shore shows the same issue.

Walkways connecting to older home foundations run into a related problem: settling unevenly right at the seams where slab sections meet. The Colony Concrete Lifting raises both patios and connecting walkways in one visit when the property calls for it, locating the void and injecting at the seam or panel edge.

What's included

What's included with Patio and Walkway Concrete Raising

Typically included: Optional: Customer prep:

  • Multi-slab inspection covering the patio and any connecting walkway
  • Injection at seams and panel joints where settling shows first
  • Full-property level verification once the lift is done
  • Hole patching to keep the surface finish consistent
  • Sealant application over patched injection points
  • Clear patio furniture, planters, and grills from the work area

How it works

How our Patio and Walkway Concrete Raising process works

  1. Site inspection photo
    Step 1

    Site inspection

    Locate uneven seams and low panels.

  2. Void location photo
    Step 2

    Void location

    Pinpoint gaps beneath each affected section.

  3. Injection at seams photo
    Step 3

    Injection at seams

    Foam placed precisely at panel joints.

  4. Controlled lift photo
    Step 4

    Controlled lift

    Slabs raised evenly across the property.

  5. Patch holes photo
    Step 5

    Level verification

    Check flush transitions at every seam.

  6. Patch and seal photo
    Step 6

    Patch and cleanup

    Holes sealed, jobsite swept.

Timeline

How long does a Patio and Walkway Concrete Raising take?

  1. 01

    Stage 1

    A single-visit job is typical for most residential patios.

  2. 02

    Free estimate

    same day
  3. 03

    Scheduling

    within the week

  4. 04

    Injection and lift

    two to five hours depending on patio size

  5. 05

    Walk-on ready

    same day

Need a schedule that fits?

Get a Free Estimate

FAQs

Patio and Walkway Concrete Raising FAQs

Can foam be used to lift a concrete slab near water?

And it's often preferred there. Foam resists moisture better than a cement-based slurry and doesn't add weight that could stress soil already affected by a fluctuating water table.

How to raise concrete that has settled at a walkway seam?

Injection targets the void right at the joint where two panels meet. Filling that specific gap lifts the panel back level with its neighbor without disturbing the rest of the walkway.

Will lifted concrete sink again after a rainy season?

It can if the underlying void isn't fully addressed. Pairing the lift with void filling and soil stabilization gives the fix better odds against repeated water table shifts.

Do patios near the lake need a permit for raising?

Typically no, unless the work is tied to a retaining wall or structural feature. Standard patio and walkway raising on private property usually doesn't require one.

Next step

Get a Patio and Walkway Concrete Raising estimate in The Colony

Call +1 (254) 364-6474 or request a free estimate through Contact. Related: Pool deck leveling · Home

---

Ask about Patio and Walkway Concrete Raising

Tell us about the project and how to reach you.

Call (254) 364-6474